From rjacostab at yahoo.com Wed May 30 14:37:23 2018 From: rjacostab at yahoo.com (Ricardo Acosta) Date: Wed, 30 May 2018 13:37:23 +0000 (UTC) Subject: [Tig] Ursa CRT References: <1094329184.6900887.1527687443873.ref@mail.yahoo.com> Message-ID: <1094329184.6900887.1527687443873@mail.yahoo.com> Hello. I am looking for clues as to what is the cause for an Ursa Diamond CRT failure:after 3 weeks of being powered down it turned on ok, all boards on, all fans on, but EHT lamp allways intermitent and no test signals.Best regards to all: Ricardo J. Acosta Bruzual.Caracas, Venezuela. From rob at cinelab.com Wed May 30 20:15:31 2018 From: rob at cinelab.com (Robert Houllahan) Date: Wed, 30 May 2018 15:15:31 -0400 Subject: [Tig] Ursa CRT In-Reply-To: <1094329184.6900887.1527687443873@mail.yahoo.com> References: <1094329184.6900887.1527687443873.ref@mail.yahoo.com> <1094329184.6900887.1527687443873@mail.yahoo.com> Message-ID: <893ED6D1-2C9E-42D3-8004-14D075CD09CA@cinelab.com> You might want to check the red LED lights on the 2111 board (lower right rack first board on the left) and if one of the two staus on you should look at the small PSU inside the deflection amp as it is likely in need of replacement or adjustment. > On May 30, 2018, at 9:37 AM, Ricardo Acosta via Tig wrote: > > Sohonet www.sohonet.co.uk sponsors the TIG. > ===== > > > Hello. I am looking for clues as to what is the cause for an Ursa Diamond CRT failure:after 3 weeks of being powered down it turned on ok, all boards on, all fans on, but EHT lamp allways intermitent and no test signals.Best regards to all: > > > Ricardo J. Acosta Bruzual.Caracas, Venezuela. > > > _______________________________________________ > http://colorist.org > To change subscription options, see http://tig.colorist.org/mailman/listinfo/tig > Robert Houllahan Scans Colorist Workflow Co-Owner 35MM 16MM 8MM B&W/Color-Lab Spirit 2K ScanStation 5K Xena 7K Scanning 8mm-16mm-35mm-VistaVision Arrilaser 2K & 4K Film Recording www.cinelab.com https://www.facebook.com/CinelabBoston